Recent content by antonyupward

Thanks @fitter30 - yes as mentioned in the OP I have the Installation and Service Manual... and I have a technical specifications document and the complete parts list. The Installation and Service Manual does provide instructions on how to set several of the CONFig and SERVice parameters - for...

Hi, Hoping someone on the forum knows more about the technical CONFIguration and SERVice menu options for the Viessmann Vitodens 100 B1KA than appears in the "Installation and Service Instructions". I am looking to see if its possible to adjust the primary circulating pump (the one internal...

Yes I think this is the conclusions I'm coming to too! Thank-you for your input. Appreciated.

You mean like one of these "Sasonco Valve Stem Extension 90 Degree Air Tire Angled Schrader Valve" :-) LOL You don't even have to take the tank valve out if understand right. Would need something a little different from the one I found in 90seconds... 90 angle with no valve + 7-8" straight...

Thanks Wayne... you are correct in terms of the situation When you say "Flexcon 18" - do you know of one that is 18" long (the ones I've found are all 275mm / 10.83")? If there is an 18" version, or even 15" that would definitely solve the problem.... If I've misunderstood (likely)... I guess...

Hi, I have an NTI T200 combi boiler/tankless DHW - installed in 2003. This for a 2 adult household. Loads are basement underfloor (approx 500 sq ft), one small radiator/towel rack, and a 120,000 BTU air handler (vents in all parts of the house - total 2000 sq ft). The house is older, but...

Hi, I have a NTI Trinity T200 Combi boiler installed 2003 and maintained consistently since then. I've been happy with its performance and economy, although I have also had a fair number of (relatively minor) issues with it - but I'm told these are "normal" (pump failure, igniters failing...

"Overheating" The Heat Exchanger That's a great point... but my understanding is that the boiler's controller is smart enough to stop firing if the boiler water temperature (i.e. the input to the DHW Heat exchanger" is likely to exceed the design maximum. Hence it seems the heat exchanger...

Well I can now report I've solved this problem and got it working... see this post Success

Hi, I wrote the orignal post in this thread... and finally I'm please to report success. I now have hot water at the faucets without a dedicated return line using a tankless heater. I've haven't changed my configuration from my original to my knowledge - so I don't know why it wasn't working...

No, I am not concerned about the warranty - the unit is more than 5 years old now anyhow. But I can't open my walls to put in a dedicated recirc line, and I don't have power under the furthest sink - so the Lang ACT-909 and Chillipepper solutions won't work for me. I did talk to Laing...

Impact of Water + Gas Use vs. Purchase and Install of Pump If you can let me know how you did the calculation to reach that conclusion I'd be interested: Option 1: Running water for 3 minutes for each shower, dishwasher run, etc. etc. - plus the gas usage with the on-demand boiler firing...

Hi, Looking for a little help selecting a pump to drive domestic hot water recirculation in my home (I am the home owner). I have a tankless hot water heater and no-dedicated return line. I don't have power available under the furthest two sinks! As far as I can tell none of the systems...

This is very helpful... Do you have a specific pump (make, model) in mind? Thanks

Thanks for your response...very helpful... Its good to hear the ACT909 does work if you install it close to the tankless rather than under the furthest sink.. a few follow-up questions... 1. Did you use the Grundfos Comfort Valves under the furthest sink and use the cold line as the...