Recent content by angus6

I do know he spec'd in the decoupling band as to the transition from the plenum to the duct I'll have to check , I'm guessing the it's a angled deflector as that's what they used in some stuff the did for us at work Once again thanks guys for the sharing of your knowledge

Marc I have a duct wizard calculator coming that should show up today, Figured it would help get me in the ballpark Thanks again for the help

Yeah , what he said :) Being a millwright I'm hoping I can stumble through this with a bit of guidance and not screw the pooch to bad:D Thanks again

Had 22 on may mind but typed 20 :D:D

Marc what I'm working around/between is the center beam in the basement and a wall and wanting to keep no deeper then 10", So I'm on the fence over 18x10 or 20x8. the 20x8 tucks up in behind the beam best as in stay s above the bottom. just need to make up my mind and start:) Thanks again for...

Marc Thanks for the help , So I'm figuring that if I bite the bullet and move the wall that 18x10 would be a good size to use ?

Wondering if I can get away with a main trunk size of 16x10 and a 32 run, House is 1160sqf 3br 1 1/2 b on basement, furnace is 69k btu lists max CFM@0.5 ESP of 1,200 Reason of size is there is a wall in the way:( , 14 x 10 would be a easer bet figure thats a no go There well also be 2ton of a/c