Brucelieb
New Member
I need a new water softener and think I can put a good one in myself.
(An education of sorts caused me to delete my original post.)
I am wondering if you all think this is something a handy DIY can accomplish.
There are only two pipes to connect, a manual to read and just plug it into the wall. Seems easy. I just have to find an appropriate Clack or Fleck system and a place to buy it?
After reading posts on this forum I see buying online is not a solution.
I figure 64,000 grains since I want to err to the over use side.
I have a neutralizer setup already and an old Hague maximizer 96 that I will remove.
Our well water is acidic and a little hard.
My pipes developed pin holes and the water left a blue stain in the tub so 25 years ago we had the original system installed. I serviced it myself. Poorly I imagine.
Any advice is welcome
(An education of sorts caused me to delete my original post.)
I am wondering if you all think this is something a handy DIY can accomplish.
There are only two pipes to connect, a manual to read and just plug it into the wall. Seems easy. I just have to find an appropriate Clack or Fleck system and a place to buy it?
After reading posts on this forum I see buying online is not a solution.
I figure 64,000 grains since I want to err to the over use side.
I have a neutralizer setup already and an old Hague maximizer 96 that I will remove.
Our well water is acidic and a little hard.
My pipes developed pin holes and the water left a blue stain in the tub so 25 years ago we had the original system installed. I serviced it myself. Poorly I imagine.
Any advice is welcome
Last edited: