Is this OK? rough in valve

Users who are viewing this thread

FJK

New Member
Messages
73
Reaction score
0
Points
0
Location
Illinois
I'm replacing an old, simple Moen tub/shower rough-in valve with a new Moen posi-temp valve. Due to space limitations of a vent pipe next to the rough-in valve, I need to come out of the cold side of the valve with a male/female 90° fitting (solder in). Is this OK? See image 15. Image 16 shows the new valve mocked up off the old valve's tub spout to indicate why I need to come out of the valve with a 90.
Finally, image 12 shows the existing plumbing that has air hammer risers & the close proximity of the vent pipe I mentioned earlier. I plan on eliminating the risers when I install the new rough-in valve. Any comments or plumbing routing suggestions for image 12.
Thanks, FJK
 

Attachments

  • MVC-015F.JPG
    MVC-015F.JPG
    12.4 KB · Views: 533
  • MVC-016F.JPG
    MVC-016F.JPG
    27 KB · Views: 693
  • MVC-012F.JPG
    MVC-012F.JPG
    11.8 KB · Views: 633
Last edited:

Jadnashua

Retired Defense Industry Engineer xxx
Messages
32,770
Reaction score
1,190
Points
113
Location
New England
My unprofessional opinion, you'll be fine. Note, those air chambers typically become useless after a few months unless you shut off the water at the main, then open up the valves and drain the pipes. The air trapped there gradually gets absorbed. You shouldn't need them, but if you want a water hammer arrestor, put in a real one - they cost about $12 each at a big box store.
 

Bob NH

In the Trades
Messages
3,310
Reaction score
9
Points
0
Location
New Hampshire
Remove the internal parts of that valve before soldering. Should be nothing but metal in there when it's hot.
 
R

Rancher

Guest
hammer arrestors cannot be buried in a wall!
Seriously? Where else would you put them, my house passed inspection with them in the walls.

Not trying to start an argument, just trying to learn for the next house.

Rancher
 

Markts30

Commercial Plumber
Messages
625
Reaction score
1
Points
0
Location
Phoenix, AZ
They can be placed in the wall but should be accessable for service/replacement... (access panel...)
 

SRdenny

Plumbing Contractor
Messages
359
Reaction score
0
Points
0
Location
SF Peninsula
In some jurisdictions, a code approved arrestor can be buried if it's manufacturer's installation instructions say it can.
 
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks